If you try and connect your roaster to your laptop and it does not come sync or come up with the little green tick then please follow these steps to get yourself back roasting.
Give this a go, connect your unit to your laptop, turn the roaster on.
Then in Studio go to;
Tools > Connection Tools > Re-connect
Tools > Connection Tools > Re-format on-board memory
Tools > Connection Tools > Re-sync
If you are still experiencing issues then please perform a reset of your roaster;
Switch off the machine
Hold down the middle button (3rd button) and at the same time, switch on the machine
Machine will show a “Resetting” message, remove your finger. If you have an old version of the firmware and are updating this, The unit will say “Reflashing”
Machine will reset itself and default to the ‘K-logic Classic’ profile
If this still does not resolve your issue then please try a different USB cable. We have found that every now and again there may be a fault or wear in a cable that can cause their connection to become spotty or not even connect at all.
0 Comments