Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Weigh 120g of green beans and load these into your roaster.

  2. Put the chaff collector in place.

  3. Hold down both the + and - buttons while you turn the roaster on. It will enter calibration mode.

  4. Press ≡ until you see ‘Press ⏵ now for fan at 14700 rpm’. Press ⏵. The fan will start.

  5. The display will show ‘fan 14700’. If it does not, turn the roaster off and start again.

  6. Look at the bean circulation. The beans should be circulating gently. Pay particular attention to the beans in the middle which should be slowly turning over.

  7. Use the + and - buttons to alter the fan speed until the beans in the middle just start to circulate.

  8. Press ⏵ twice to save the setting. The display will briefly show ‘Saved'.

  9. Turn the roaster off to exit calibration mode.

View file
nameInvalid file id - 31e2eae3-9fd3-44e6-a83c-44a2384f628a
Notes
  • See below for how to select suitable beans.

  • If you have a mesh chaff collector with an opaque chimney you will have to remove the chaff collector lid so that you can see the beans.

  • Take care to alter ‘fan at 14700 rpm’. There are other calibration settings which should not be changed except under instructions from an authorised authorized Kaffelogic service agent.

  • Fan speed calibration at 14700 rpm requires firmware version 7.10 or higher. If you need to update, see Update firmware.

...